Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Messages
AreaID: Is the area id of the requested OSPF area.
External Routing: Is a number representing the external routing capabilities for this area.
Spf Runs: Is the number of times that the intra-area route table has been calculated using this
area's link-state database.
Area Border Router Count: The total number of area border routers reachable within this area.
Area LSA Count: Total number of link-state advertisements in this area's link-state database,
excluding AS External LSAs.
Area LSA Checksum: A number representing the Area LSA Checksum for the specified AreaID
excluding the external (LS type 5) link-state advertisements.
Stub Mode: Represents whether the specified Area is a stub area or not. The possible values are
enabled and disabled. This is a configured value.
Import Summary LSAs: Shows whether to import summary LSAs (enabled).
The following OSPF NSSA specific information displays only if the area is configured as an
NSSA.
Import Summary LSAs: Shows whether to import summary LSAs into the NSSA.
No-Redistribute into NSSA: Shows whether to redistribute information into the NSSA.
Default Information Originate: Shows whether to advertise a default route into the NSSA
Default Metric: Shows the metric value for the default route advertised into the NSSA.
Default Metric Type: Shows the metric type for the default route advertised into the NSSA.
Translator Role Shows the NSSA translator role of the ABR, which is always or candidate.
Translator Stability Interval: Shows the amount of time that an elected translator continues to
perform its duties after it determines that its translator status has been deposed by another router.
Translator State: Shows whether the ABR translator state is disabled, always, or elected.
To Next Page
Loading...
Need help?
General