Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 910/1523
9.4.2.5 ipv6 ospf hello-interval
This command sets the OSPF hello interval for the specified interface. The value for <seconds> is a
valid positive integer, which represents the length of time in seconds. The value for the length of time
must be the same for all routers attached to a network. Valid values for <seconds> range from 1 to
65535.
ipv6 ospf hello-interval <seconds>
no ipv6 ospf hello-interval
<no> - This command sets the default OSPF hello interval for the specified interface.
Default Setting
10
Command Mode
Interface Config
9.4.2.6 ipv6 ospf mtu-ignore
This command disables OSPF maximum transmission unit (MTU) mismatch detection. OSPF Database
Description packets specify the size of the largest IP packet that can be sent without fragmentation on
the interface. When a router receives a Database Description packet, it examines the MTU advertised by
the neighbor. By default, if the MTU is larger than the router can accept, the Database Description
packet is rejected and the OSPF adjacency is not established.
ipv6 ospf mtu-ignore
no ipv6 ospf mtu-ignore
<no> - This command enables the OSPF MTU mismatch detection.
Default Setting
Enabled
Command Mode
Interface Config
To Next Page
Loading...
Need help?
General