_____________________________________________________________________________
LB9 User’s Guide 917/1523
9.4.2.18 area nssa translator-stab-intv
This command configures the translator stability interval of the NSSA. The <stabilityinterval> is the
period of time that an elected translator continues to perform its duties after it determines that its
translator status has been deposed by another router.
<areaid> - Area ID.
<0-3600> - The range is 0 to 3600.
no - Disables the nssa translator’s <stabilityinterval> from the specified area id.
Default Setting
None
Command Mode
Router OSPFv3 Config
To Next Page
Loading...
Need help?
General