_____________________________________________________________________________
LB9 User’s Guide 929/1523
9.4.2.33 external-lsdb-limit
This command configures the external LSDB limit for OSPF. If the value is -1, then there is no limit.
When the number of non-default AS-external-LSAs in a router's link-state database reaches the external
LSDB limit, the router enters overflow state. The router never holds more than the external LSDB limit
non-default AS-external-LSAs in it database. The external LSDB limit MUST be set identically in all
routers attached to the OSPF backbone and/or any regular OSPF area.
<-1-2147483647> - The range of external LSDB limit for OSPF is -1 to 2147483674.
no - This command configures the default external LSDB limit for OSPF.
Default Setting
-1
Command Mode
Router OSPFv3 Config
9.4.2.34 maximum-paths
This command sets the number of paths that OSPF can report for a given destination where
<maxpaths> is platform dependent.
<1-2> - The maximum number of paths that OSPF can report for a given destination. The range of
the value is 1 to 2.
no - This command resets the number of paths that OSPF can report for a given destination back to
its default value.
Default Setting
1
Command Mode
Router OSPFv3 Config.
To Next Page
Loading...
Need help?
General