Receiver Mode
R&S
®
ESR
218User Manual 1175.7068.02 ─ 12
Defining a margin
A margin is similar to a limit, but less strict and it still belongs to the valid data range. It
can be used as a warning that the limit is almost reached. The margin is not indicated
by a separate line in the display.
► Enter a value in the "Margin" field of the "Edit limit Line" dialog box.
If the limit line is defined as an upper limit, the margin is below the limit line. If the
limit line is defined as a lower limit, the margin is above the limit line.
Entering a new data point
1. Press the "Insert value" button in the dialog, or select an existing data point in the
table and press the Insert Value softkey.
2. Enter the new position (x) and value (y) in the edit dialog box.
Changing a data point
1. Press on the data point to be changed in the table.
2. Enter the new position (x) and value (y) in the edit dialog box.
Deleting a data point
1. Press on the data point to be deleted in the table.
2. Press the "Delete" button in the dialog.
Shifting a limit line horizontally
► Select the "Shift x" button and enter a shift width for the x value in the edit dialog
box.
Common Analysis Functions
To Next Page
Loading...
Need help?
General
