Spectrum Measurements
R&S
®
ESR
224User Manual 1175.7068.02 ─ 12
Spurious Emissions
Opens a submenu to configure the Spurious Emissions measurement.
The Spurious Emissions measurement defines a measurement that monitors unwan-
ted RF products outside the assigned frequency band generated by an amplifier.
For details see Chapter 6.1.1.6, "Measuring Spurious Emissions", on page 283.
Remote command:
SENS:SWE:MODE LIST, see [SENSe:]SWEep:MODE on page 761
Time Domain Power (zero span)
Activates the power measurement in zero span and opens a submenu to configure the
power measurement. For details see Chapter 6.1.1.7, "Measuring the Power in Zero
Span", on page 294.
Remote command:
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary[:STATe] on page 801
All Functions Off
Switches off all power measurement functions.
APD
Activates the function to measure the amplitude probability density (APD) and opens a
submenu.
For details see Chapter 6.1.1.10, "Calculating Signal Amplitude Statistics",
on page 312.
Remote command:
CALCulate<n>:STATistics:APD[:STATe] on page 792
CCDF
Activates the function to measure the complementary cumulative distribution function
(CCDF) and opens a submenu.
For details see Chapter 6.1.1.10, "Calculating Signal Amplitude Statistics",
on page 312.
Remote command:
CALCulate<n>:STATistics:CCDF[:STATe] on page 792
TOI
Opens a submenu and activates the measurement of the 3rd order intercept point.
For details see Chapter 6.1.1.11, "Measuring the Third Order Intercept Point (TOI)",
on page 330.
Remote command:
CALCulate<n>:MARKer<m>:FUNCtion:TOI[:STATe] on page 790
CALCulate<n>:MARKer<m>:FUNCtion:TOI:RESult? on page 791
AM Mod Depth
Opens a submenu and activates the measurement of the AM modulation depth. An
AM-modulated carrier is required on the screen to ensure correct operation.
For details see Chapter 6.1.1.12, "Measuring the AM Modulation Depth", on page 336.
Measurements