R&S ESR Series

Remote Control
R&S
®
ESR
875User Manual 1175.7068.02 ─ 12
Suffix:
<n>
.
Selects the measurement window.
<m> Selects the marker.
Parameters:
<Duration> Range: 10 ms to 1000 s
*RST: Marker demodulation = OFF
Example:
CALC:MARK:FUNC:DEM:HOLD 3s
Manual operation: See "Mkr Stop Time" on page 420
CALCulate<n>:MARKer<m>:FUNCtion:DEModulation:SELect
<DemodMode>
This command selects the demodulation mode for the audio demodulator.
Suffix:
<n>
.
Selects the measurement window.
<m> irrelevant
Parameters:
<DemodMode> AM | FM
*RST: AM
Example:
CALC:MARK:FUNC:DEM:SEL FM
Manual operation: See "AM" on page 420
See "FM" on page 420
CALCulate<n>:MARKer<m>:FUNCtion:DEModulation[:STATe] <State>
This command turns the audio demodulator on and off when the measurement rea-
ches a marker position.
In the frequency domain, the hold time can be defined at the corresponding marker
position with CALCulate<n>:MARKer<m>:FUNCtion:DEModulation:HOLDoff.
In the time domain continuous demodulation is always on.
Suffix:
<n>
.
Selects the measurement window.
<m> Selects the marker.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
CALC:MARK3:FUNC:DEM ON
Switches on the demodulation for marker 3.
Manual operation: See "Mkr Demod On/Off" on page 420
Remote Commands in Spectrum Analyzer Mode