R&S ESR Series

Remote Control
R&S
®
ESR
913User Manual 1175.7068.02 ─ 12
Manual operation: See "Source RF Internal (On/ Off)" on page 477
SYSTem:COMMunicate:GPIB:RDEVice:GENerator<generator>:ADDRess
<Number>
Changes the IEC/IEEE-bus address of the external tracking generator.
This command is only available if the R&S FSV-B10 option (External Tracking Genera-
tor) is installed.
Suffix:
<generator>
.
1 | 2
tracking generator
For Noise Figure measurements (K30): 1 only
Parameters:
<Number> Range: 0 to 30
*RST: 28
Example:
SYST:COMM:GPIB:RDEV:GEN1:ADDR 15
Mode: A, NF
SYSTem:COMMunicate:RDEVice:GENerator<generator>:INTerface <Type>
Defines the interface used for the connection to the external tracking generator.
This command is only available if the R&S FSV-B10 option (External Tracking Genera-
tor) is installed.
Suffix:
<generator>
.
1 | 2
tracking generator
For Noise Figure measurements (K30): 1 only
Parameters:
<Type> GPIB | TCPip
*RST: GPIB
Example:
SYST:COMM:RDEV:GEN1:INT TCP
Mode: A, NF
Manual operation: See "Interface" on page 491
SYSTem:COMMunicate:RDEVice:GENerator<generator>:LINK <Type>
This command selects the link type of the external generator if the GPIB interface is
used.
Remote Commands to Control the Tracking Generator