Ross Vision - Page 32

Ops 2–6 • Control Panel Introduction Vision Operator’s Manual (v12.0 MD)
Vision 1 Control Panel
The Vision 1 control panel (Figure 2.8) has 1 Panel Row, 16 Crosspoint Buttons per Bus, 16
Custom Control Buttons, a Transition Module, a Keyer Module, and a Positioner Module as
standard.
Figure 2.8 Vision 1 Control Panel (4-Keyer Shown)
1. Effects Memory Module
The Effects Memory Module allows you to store and recall memory registers within each MLE.
On the Vision 1, 1M, 2, and 2M control panels, the Global Memory Module is used to store and
recall memories. Unlike the Global Memory Module, the Effects Memory Module applies only
to the individual MLE it is assigned to, and not the entire control panel.
In addition to memory register functions, you can assign MLE transition rates and key transition
rates for the MLE. The display above the keypad on the Effects Memory Module shows the
current auto transition rate, key transition rate, and current memory register.
For More Information...
• on storing and recalling memories, refer to the section “Storing and Recalling
Memories” on page Ops 8-6.
2. Transition Module
The Transition Module allows you to select the type of transition, what is transitioned, and how
the transition is performed on the selected MLE.
• Transition Type Buttons — These buttons allow you to select the type of transition that
you want to perform during the next transition. You can choose between the following:
789
456
123
+/-
0
.
BANK CLEAR ENTER
MLE
2
MLE
1
ALL
MLE
4
MLE
3
MLE
2
MLE
1
RECALL
CLIP
ALL
MLE
4
MLE
3
FADE
RATE
MLE
RATE
EFF
RATE
KEY
RATE
UNDO
ATTRIB
KEYS
ONLY
EFF
DISS
G LOBAL M EMORY
SEL
BKGD
T RANSITION
KEY 1 KEY 2
FRAMES
KEY 3
PST
BKGD
TRANS
PV
KEY
PRIOR
TRANS
LIMIT
DISS
ROLL
CLIP
WIPE DVE SEQ
KEY 4
CUT
AUTO
TRANS
0 1 5
K EYERS
SELF
KEY
AUTO
SELECT
CHROMA
KEY
PST
PATT
MATTE
FILL
KEY
MEM
KEY
INV
MASK
FLY
KEY
CHNL
MGMT
BORD
ON
BORD
OFF
SHOW
ALPHA
KEY
PV
CUT CUT CUT CUT
AUTO
TRANS
AUTO
TRANS
AUTO
TRANS
AUTO
TRANS
CUT
AUTO
TRANS
CUT
AUTO
TRANS
SEL SEL SEL SEL SEL SEL
123456
LINK
HOLD
CLEAR
P OSITIONER
F ADE T O B LACK
CUT FADE
F RAMES USB
0 1 5
O VERLAY
SAFE
TITLE
SOURCE
ID
P REVIEW
SRCPVPGM
MLE
PV
MLE
PGM
2
4
5
6
7
8
9
11
10
1) Effects Memory Module
2) Transition Module
3) Keyers Module
4) Preview Module
5) Preview Overlay Module
6) Fade to Black Module
7) Keyers Module (Downstream)
8) Global Memory Module
9) Positioner Module
10)Crosspoint Group
11) Custom Control Group