Ross Vision - Page 33

Vision Operator’s Manual (v12.0 MD) Control Panel Introduction • Ops 2–7
› DISS — Select this transition type to have a Dissolve performed during the next
transition.
› WIPE — Select this transition type to have a Wipe performed during the next
transition.
› DVE — Select this transition type to have a Squeeze & Tease Wipe performed
during the next transition.
› SEQ — Select this button to use the Transition Module to run a Sequence. A
sequence does not perform a transition and will not transition any sources on or
off-air.
• Next Transition Buttons — These buttons allow you to select what is transitioned
during the next transition. You can transition almost any combination of keys and
background at the same time. You can choose between the following:
› BKGD — Toggle this button On to have a transition performed between the
Background and Preset buses.
› KEY1 — Toggle this button On to have Key 1 transitioned on-air or off-air with the
next transition. If Key 1 is on-air, it will be transitioned off-air.
› KEY2 — Toggle this button On to have Key 2 transitioned on-air or off-air with the
next transition. If Key 2 is on-air, it will be transitioned off-air.
› KEY3 — Toggle this button On to have Key 3 transitioned on-air or off-air with the
next transition. If Key 3 is on-air, it will be transitioned off-air.
› KEY4 — Toggle this button On to have Key 4 transitioned on-air or off-air with the
next transition. If Key 4 is on-air, it will be transitioned off-air.
Transitions are performed manually using the Fader, or automatically using the AUTO TRANS
button.
For More Information...
• on transition types, refer to the section “Transition Types” on page Ops 5-7.
• on the next transition buttons, refer to the section “Next Transition Select” on page Ops
5-3.
3. Keyers Module
The Keyers Module allows you to select the key type and associated parameters for all the keys
on the selected MLE. You can choose between Self Key, Auto Select
(Linear) Key,
UltraChr
ome Advanced Chroma Key, and Preset Pattern Key. You can also select a variety of
parameters and key transitions for the selected key.
The Keyers Module is assigned to a key by pressing the associated SEL button for the Keyer.
When the SEL button for a Keyer is selected, the Key Bus on the MLE, and the Keyer Module,
are assigned to that key.
The Vision switcher supports a 2-Keyer and 4-Keyer, Keyers Module for each MLE, depending
on whether the 4-Keyer option has been installed.
For More Information...
• on the Keyers Module, refer to the section “Keyers Module” on page Ops 7-2.
• on key priority, refer to the section “Video Layering” on page Ops 4-3.
• on performing a key over transition, refer to the section “KEY PRIOR” on page Ops
5-4.
4. Preview Module
The Preview Module allows you to select what video signal is fed out of the Preview output of
the switcher. You can select either the Program or Preview output of each MLE on the switcher,
or you can select a specific video source.