Ross Vision - Page 34

Ops 2–8 • Control Panel Introduction Vision Operator’s Manual (v12.0 MD)
For More Information...
• on using the Preview Bus Module, refer to the section “Preview Module” on page Ops
4-14.
5. Preview Overlay Module
The Preview Overlay Module allows you to control specific overlay information that is shown
on the over top of the preview output. This information includes VTR Timecodes, Countdown
Timers, Source ID, and Safe Title.
For More Information...
• on using the Preview Overlay Module, refer to the section “Preview Overlay” on
page Ops 4-16.
6. Fade to Black Module
The Fade to Black Module allows you to fade, or cut, the output of the switcher to black. This
can be set up for all MLEs, or just the Program output of the switcher. The display on the module
shows the current fade-to-black transition rate.
A USB port on the Fade to Black Module allows you to store and recall switcher setups onto a
USB flash drive.
If you have the SmartConversion™ option installed, you can have this display show the number
of free converters on the switcher.
For More Information...
• on setting up SmartConversion, refer to the section “Switcher Setup” on page Eng 16-5.
• on storing and recalling files, refer to the section “Storing and Recalling Files and
Setups” on page Eng 13-4.
7. Keyer Module (Downstream)
The Keyer Module allows you to select the key type and associated parameters for all the keys
on the Program/Preset MLE. You can choose between Self Key, Auto Select (Linear) Key,
UltraChrome Advanced Chroma Key, and Preset Pattern Key. You can also select a variety of
parameters and key transitions for the selected key.
The Keyer Module operates the same as the Keyer Module, with the addition of Keyers 5 and 6
that are used for the MultiDSK option.
If you have a Half MLE switcher, only Self Keys and Auto Select Keys can be performed on the
MultiDSK Keys.
The Keyers Module is assigned to a key by pressing the associated SEL button for the Keyer.
When the SEL button for a Keyer is selected, the Key Bus on the MLE, and the Keyer Module,
are assigned to that key.
A 6-Keyer, Keyers module is available for switchers that have both the 4-Keyer and MultiDSK
options installed.
For More Information...
• on the Downstream Keyer Module
, refer to the section “Key
ers Module” on page Ops
7-2.
• on MultiDSK, refer to the section “MultiDSK Keys” on page Ops 7-37.
• on performing a key over transition, refer to the section “KEY PRIOR” on page Ops
5-4.
• on key priority, refer to the section “Video Layering” on page Ops 4-3.