Ops 4–30 • Switcher Basics Vision Operator’s Manual (v12.0 MD)
• Adjust the RGB Components as follows:
› Press RGB Adjust on the RGB Menu 2-2.
RGB Adjustment — RGB Menu 2-2
›Use the Gain knob on the RGB Menu 2-2 to adjust the gain of all the
components. The graphs update to reflect your selection.
›Use the Offset knob on the RGB Menu 2-2 to adjust the offset of all the
components. The graphs update to reflect your selection. Offset moves the line
towards the top left or bottom right corner.
›Use the Lower Offset knob on the RGB Menu 2-2 to adjust the lower offset
of all the components. The graphs update to reflect your selection. The lower
offset moves the minimum point on the graph along either the vertical axis or
horizontal axis.
• Adjust the Gamma of the RGB Component as follows:
› Press RGB Gamma on the RGB Menu 2-2.
RGB Gamma — RGB Menu 2-2
•Use the Gamma Value knob on the RGB Menu 1-2 to adjust the gamma of all the
components.
•Use the Gamma Offset knob on the RGB Menu 1-2 to adjust the offset of the
gamma of all the components. The gamma offset value moves the offset point along
the graph line and the gamma value alters how much perpendicular offset is applied
to the offset point.
Note — The Green and Blue components are adjusted in the same way as the Red. Use the
information provided in Step (4.) to adjust either of these components.
4. Adjust the Red Component as follows:
• Adjust the Red Component as follows:
To Next Page
Loading...
