OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 MAY 2009
MMC: 300 CUSTOMER ON/OFF PER STATION
DESCRIPTION:
Allows the following features to be enabled on a per-station basis.
ACCESS DIAL Determines whether a user can select a trunk or trunk group
by dialling its directory number (DN). This selection should
be turned to off when using LCR.
MICROPHONE This option allows or denies the use of a keyset’s
microphone if equipped.
OFF-HOOK RING Will allow a short burst of ring tone to indicate another call.
SMDR PRINT When the station is set for no C.O. calls to and from this
station, the station will not print on SMDR. This includes
transferred calls or calls picked up from hold or park.
TGR ADV.TONE When this feature is set to ON, a warning tone will be heard
each time LCR advances to the next route.
VMAA FORWARD This feature selects whether C.O. calls can be forwarded to
voice mail.
ON = Permits forward to voice mail.
OFF = No forward to voice mail.
INTRCOM SMDR When the station is set to OFF, the station will not print
intercom calls on SMDR.
FWD OVRD When set to OFF intercom calls from this station will not
follow the call forwarding of the called station.
RECL TO OPER This option determines if a transferred call will recall to the
transferring station (OFF) or to the operator (ON).
SLT LP OPEN This option only applies to single line ports. When this option
is set to ON the SLT port will receive a Loop Open Disconnect
if the calling or called party hangs up before the SLT. This
option does not affect ports set as DATA or VMAA in MMC
207/208, these ports will always receive a disconnect
regardless of this setting.
To Next Page
Loading...
