Samsung OFFICESERV 7100 - MMC: 857 VIRTUAL CABINETS

OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 MAY 2009
MMC: 857 VIRTUAL CABINETS
DESCRIPTION: [Applies to v.4.30 or Higher]
This MMC is used to configure Virtual Cabinet slots. Virtual Cabinets contain devices
that are not physical such as SIP trunks, Virtual Single Line Phones, or MOBEX
stations. Because these devices are not tied to a physical port they are considered to
be virtual devices and as such reside in a Virtual Cabinet. The OfficeServ 7100 has 6
Virtual Cabinets numbered 2 through 7. Each Virtual Cabinet has 3 slots, numbered 1
through 3, with 8 ports per slot.
MMC 857 configuration directly affects the appearance in the numbering plan
(MMC 724) for these devices.
The available Virtual Cabinet assignments are shown below, with defaults highlighted in
green:
Virtual
Cabinet
Slot 1 Slot 2 Slot 3
Virtual
Cabinets
Slot 1 Slot 2 Slot 3
SLT DGP DGP WIRED ITP WIRED ITP WIRED ITP
DGP SLT SLT SLT WLAN ITP WLAN ITP
WIRED ITP WIRED ITP WIRED ITP DGP SIP STN SIP STN
WLAN ITP WLAN ITP WLAN ITP WLAN ITP SPNET TRK SPNET TRK
SIP STN SIP STN SIP STN SIP STN SIP TRK SIP TRK
2
MOBEX STN MOBEX STN MOBEX STN
3
MOBEX STN MOBEX STN MOBEX STN
WLAN ITP NONE GCONF STN SPNET TRK SIP TRK H323 TRK
WIRED ITP GCONF STN SPNET TRK GCONF STN GCONF STN GCONF STN
SIP STN SPNET TRK SIP TRK SIP TRK SPNET TRK SPNET TRK
SPNET TRK SIP TRK MOBEX STN H323 TRK H323 TRK SIP TRK
SIP TRK MOBEX STN
4
MOBEX STN
5
MOBEX STN MOBEX STN MOBEX STN MOBEX STN MOBEX STN MOBEX STN
6
DGP DGP DGP
7
DGP DGP DGP
Home Page
Table of Contents