OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 APRIL 2007
MMC: 306 HOT LINE
DESCRIPTION:
Allows a station the ability to make a predetermined call similar to a ringdown
circuit, upon the expiration of a timer (see MMC 502 STN TIMERS, Off-Hook
Selection Timer). The hotline destination can be a station, a station group, a trunk, a
trunk group or an external number. There can be a maximum of 18 digits in the dial
string for the external number. The access code for the trunk or trunk group access
code is not counted as part of the 18.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPEAKER Used to store data and advance to next MMC
HOLD Used to clear previous entry
B Used to insert a flash code “F”
C Used to insert a pause code “P”
D Used to insert a pulse/tone conversion code “C”
E Used to mask/unmask following digits—shows as “[” or “]”
F Used to enter name for speed dial bin (see MMC 106)
ACTION DISPLAY
1. Press TRANSFER 306
Display shows
[201] HOT LINE
NONE
2. Dial station number
OR
[205] HOT LINE
NONE
Use UP or DOWN to scroll through stations
Press RIGHT soft key to move the cursor.
3. Enter the hot line destination ie a station
or trunk ID (e.g., 9 or 701) with a maximum
[205] HOT LINE
9-1305P4264100_
of 24 outgoing digits after the access code
for the CO call (see above list of options if
needed).
Bottom row of program keys are options B–E.
To Next Page
