OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 APRIL 2007
MMC: 200 OPEN CUSTOMER PROGRAMMING
DESCRIPTION:
Used to open (enable) and close (disable) customer-level programming. If
programming is not opened and an attempt is made to access a system MMC, the
error message [NOT PERMIT] will be displayed. A four digit passcode is required to
access this MMC. Each digit can be 0-9. When opened, this MMC enables access to
all MMCs allowed in MMC 802 Customer Access MMC Number.
PROGRAM KEYS
UP & DOWN Select open or closed
KEYPAD Used to enter passcode
SPEAKER Save data and advance to next MMC
TRANSFER Exit Programming
ACTION DISPLAY
1. Press TRANSFER 200
Display shows
ENABLE CUS.PROG.
PASSCODE:
2. Enter passcode.
ENABLE CUS.PROG.
PASSCODE:
Correct code shows.
ENABLE CUS.PROG.
DISABLE
Incorrect code shows.
ENABLE CUS.PROG.
PASSWORD ERROR
3. Press UP or DOWN arrow key to select
ENABLE or DISABLE and press RIGHT soft
ENABLE CUS.PROG.
ENABLE
key
OR
Dial 1 for ENABLE or 0 for DISABLE.
To Next Page
Loading...
