OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 MAY 2009
MMC: 861 SYSTEM OPTION
DESCRIPTION: [Applies to v.4.30 or Higher]
This MMC is used to set various system wide options. The list below describes each
option’s purpose.
OPTIONS
0 AUTO UPDATE TIME NOT FOR USE IN THE USA
SYSTEM SPEED BIN This option determines the maximum number
of system speed dial numbers. When set to the
default, MAX 500, the system will have a
maximum of 500 system speed dial bins
numbered 500 to 999. When set to MAX 950
the system will have a maximum of 950 system
speed dial bins numbered 050 to 999. Station
speed dial bins will be 000 to 049.
NOTE: Personal speed dial numbers change
from 2 to 3 digits when MAX 950 is selected.
IDLE WHEN ENBLOCK This option determines the idle status for 2 line
ITP keysets that are dialling in ENBLOCK
mode. When enabled ITP-5121D and ITP-
5107S keysets that are dialling when an
incoming call is received will have dialling
cancelled to present the ringing call. When
disabled incoming calls will not disrupt dialling.
Note: This option has no effect if 2LINE
ENBLOCK below is set to DISABLE.
2 LINE ENBLOCK When this option is enabled the ITP-5121D
and ITP-5107S keysets must press the SEND
button after dialling to place a call. This
operates like a cell phone. When disabled
digits are sent as dialled with no need to press
SEND.
SPNET OVERLAP NOT FOR USE IN THE USA
To Next Page
