OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 MAY 2009
MMC: 321 SEND CLI NUMBER
DESCRIPTION:
This MMC allows you to set the outbound Caller ID number (CLI) for each station and
trunk in the system. This information will be sent during PRI trunk calls, SIP trunk calls,
optionally during SPNET trunk calls, and H.323 trunk calls. There are 4 CLI tables
(tables 0 ~ 3) in the system so you can set different CLI numbers for each station
depending on which trunk is accessed or what type of call is being made. Each CLI
number can be up to 16 digits long.
Each station and trunk number also has an associated SIP ALIAS field (table 4) that
allows you to set a Caller ID Name of up to 16 characters that will be sent when
calling to a SIP peer.
NOTE: Not all service providers allow you to set outgoing caller ID number or name,
and some may restrict numbers that can be used.
PROGRAM KEYS
UP & DOWN Used to scroll through options/move cursor left or right
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPEAKER Used to store data and advance to next MMC
HOLD Used to clear previous entry
ACTION DISPLAY
1. Press TRANSFER 321.
Display shows first station port.
[201] CLI NUMB 1
2. Dial extension (e.g., 230)
OR
[230] CLI NUMB 1
Press UP or DOWN to select extension and press
RIGHT soft key to move the cursor.
3. Dial table number 0 ~ 4.
OR
[230] CLI NUMB 1
_
Press UP or DOWN to select table number and
press RIGHT soft key to move the cursor.
To Next Page
Loading...
