Samsung OFFICESERV 7100 - MMC: 810 HALT PROCESSING

OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 APRIL 2007
MMC: 810 HALT PROCESSING
DESCRIPTION:
Used only in the event that all data processing needs to be stopped either in a
single cabinet, slot or in the entire system.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPEAKER Used to store data and advance to next MMC
ANS/RLS Used to select ALL
ACTION DISPLAY
1. Press TRANSFER 810.
Display shows.
HALT/PROCESSING
C:ALL S:ALL→ PROC
2.
Enter cabinet selection via dial keypad
OR
HALT/PROCESSING
C:1 S:ALL→ PROC
Press UP or DOWN key to make selection.
Press RIGHT soft key to advance cursor.
Press ANS/RLS to select all cabinets
and slots.
HALT/PROCESSING
C:ALL S:ALL →PROC
3.
Enter slot number via dial keypad
OR
HALT/PROCESSING
C:ALL S:ALL →HALT
Press UP or DOWN key to make selection.
Press RIGHT soft key to advance cursor.
4.
Enter 1 for HALT or 0 to PROC
OR
Press UP or DOWN key to make selection.
Press RIGHT soft key to enter and return to
step 2.
Home Page
Table of Contents