OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 MAY 2009
MMC: 104 STATION NAME
DESCRIPTION:
Allows the system administrator or technician to enter an 11-character name to
identify an individual station.
Messages are written using the keypad. Each press of a key will select a character.
Pressing the dial pad key will move the cursor to the next position. For example, if the
directory name is “SAM SMITH” press the number “7” three times to get the letter “S”.
Now press the number “2” once to get the letter “A”. Continue selecting characters
from the table below to complete message. Pressing the “A” key will change the letter
from upper case to lower case.
NOTE: When the character you want appears on the same dial pad key as the
previous character, press the UP key to move the cursor to the right.
NOTE: When STATION NAME is set to YES in MMC 704 changes to this MMC will
also be saved as the station’s voicemail Subscriber Name (provided the station has
voicemail).
• iDCS, DS and ITP KEYSETS
COUNT 1 2 3 4 5
DIAL 0 < > . ) 0
DIAL 1 space ? , ! 1
DIAL 2 A B C @ 2
DIAL 3 D E F # 3
DIAL 4 G H I $ 4
DIAL 5 J K L % 5
DIAL 6 M N O ^ 6
DIAL 7 P Q R S 7
DIAL 8 T U V
4
8
DIAL 9 W X Y Z 9
DIAL 4 : = [ ]
4
1. When the character you want appears on the same dial pad key as the previous
character, press UP to move the cursor one space to the right.
2. Other symbols are available for DIAL #.
To Next Page
Loading...
