OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 APRIL 2007
MMC: 723 SYSTEM KEY PROGRAMMING
DESCRIPTION:
This MMC is much like MMC 722, Station Key Programming. The main difference is
that this MMC is system-wide rather than on a per-station basis. Features are entered
via the dial keypad by pressing numbers as shown in the table. For example, for
OHVA the number 6 is pressed three times. If the BOSS key is required, press 2 for
the first letter B, and then use the UP or DOWN key to change selection from BARGE
to BOSS.
DIAL KEYPAD
COUNT→
1 2 3
DIAL 2 ABAND BARGE CAD
DIAL 3 DGPALM EP FAUTO
DIAL 4 GPIK HDSET
DIAL 5 LANREQ LANREQ LANREQ
DIAL 6 MMPA NEW OHVA
DIAL 7 PAGE PAGE RB
DIAL 8 TCLIP UA VM
TYPE OF SET
24-BTN
12-BTN
7-BTN
64-BTN AOMs
28 BTN
18 BTN
BTN
99 BTN – NOT AVAILABLE IN US
38 BTN – NOT AVAILABLE IN US
21 BTN
14 BTN – NOT AVAILABLE IN US
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPEAKER Used to store data and advance to next MMC
HOLD Used to clear previous entry
To Next Page
Loading...
