OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 APRIL 2007
MMC: 419 DISTINCTIVE RINGING
DESCRIPTION:
Allows the technician to assign the ring tone be sent by the calling station or trunk
to the called (receiving) station. There is also a cadence control option to perform a
similar function for single line sets. There are eight ring tones available for the
phones. There are 5 cadences for SLT’s.
It also allows the technician to assign the call priority for a group call when called by
a specific station or when a specific trunk rings that phone. When calls into station
group come and group members are all busy, the system will assign a priority to a
specific station or a specific station or a specific trunk so that calls from a high
priority call will be placed at the front of the group queue. If this option is set to NO,
the longest call that placed at the group queue has the highest priority. There are 9
priority levels: priority 1 is the highest and priority 9 is the lowest.
TONE OPTION DESCRIPTION
NO Calls will ring with the digital phone users choice of ring
frequency.
1~8 Calls from the programmed station or trunk will ring phones
with this ring frequency.
CADENCE OPTION DESCRIPTION
NO Calls will ring with the normal SLT ring cadences.
1 Calls from the programmed station or trunk will ring SLT’s
with the intercom ring cadence.
2 Calls from the programmed station or trunk will ring SLT’s
with the CO ring cadence.
3 Calls from the programmed station or trunk will ring SLT’s
with the DOOR ring cadence.
4 Calls from the programmed station or trunk will ring SLT’s
with the ALARM ring cadence.
5 Calls from the programmed station or trunk will ring SLT’s
with the CALLBACK ring cadence.
To Next Page
Loading...
