Samsung OFFICESERV 7100 User Manual

OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 APRIL 2007
MMC: 315 CUSTOMER SET RELOCATION
DESCRIPTION:
Customer Set Relocation allows System Administration level or Technician level
access to relocate or exchange similar stations in the OfficeServ 500 without wiring
changes (see Allow Table bellow). This program is a one for one exchange with like
stations. All individual station assignments such as trunk ring, station group, station
COS, station speed dial, button appearances, etc. will follow the Customer Set
Relocation program. iDCS 18 button keysets and iDCS 28 button keysets can be
exchanged. Add On Modules and 64 button modules can also be exchanged. If
incompatible set types are selected the system will provide an ERROR: NO MATCH
message. If AOM or 64 button module units are to be exchanged the Master
assignment must be removed prior to using Customer Set relocation. If the AOM or
64 button module Master station is not removed the error code ERROR: NOT
ALONE will appear on the LCD display. A station must be in the idle state (on hook)
to perform Customer Set Relocation. If a wired location has a station port connected
but no telephone instrument the Customer Set Relocation program will allow set
relocation as long as the station types are similar.
iDCS 18 button and iDCS 28 button key assignments should be taken in
consideration when relocating these types of sets due to the button configurations
of the instruments. If a 18 button set and a 28 button set are exchanged using the
Customer Set Relocation program the first 18 buttons on the 24 button set will have
the button programming of the 18 button set. In other words, when exchanging 18
and 28 button set only the first 18 buttons will swapped.
NOTE: Customer access to this feature is default OFF in MMC 802.
Home Page
Table of Contents

Samsung OFFICESERV 7100 Specifications

General

Brand	Samsung
Model	OFFICESERV 7100
Category	Telephone System
Language	English