OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 APRIL 2007
MMC: 846 WIP INFO
DESCRIPTION:
[MMC846] is used to display the handset information and set some parameters.
You can change USER ID, PASSWORD, and INSERT DGT.
No. Parameter Description
0 REGISTERED Indicates whether the corresponding handset is registered
1 LOCATED Indicates whether the corresponding handset is currently connected to
the system
2 PHONE TYPE Indicates the type of the handset
5 IP OFFSET Location of the IP pool where the IP assigned to handset is located
6 IP ADDRESS IP address assigned to the registered handset
7 MAC ADDR MAC address of the registered handset
8 USER ID Sets ID by the handset user
9 PASSWORD Sets password by the handset user
10 INSERT DGT If the number of digits you pressed when originating a call in handset is
more than 5, the set INSERT DGT is inserted before the number you
pressed.
However, the number you pressed should not be C.O. Line number, C.O.
Line group number, LCR, network LCR, or number starting with the
function code
ACTION DISPLAY
1. Select the MMC number [846].
[3301] REGISTERED
NO
2. Select a desired handset number.
Or select a desired handset number
[3301] REGISTERED
NO
using the [▼Volume▲] button, and press
[RIGHT] soft button to move the cursor.
3. Enter a desired item number.
Or select a desired item using the
[3301] LOCATED
DETACH
[▼Volume▲] button, and press [RIGHT]
soft button to move the cursor.
To Next Page
Loading...
