Samsung OFFICESERV 7100 - MMC: 800 ENABLE TECHNICIAN PROGRAM

OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 APRIL 2007
MMC: 800 ENABLE TECHNICIAN PROGRAM
DESCRIPTION:
Used to open and close technician-level programming. If programming is not opened
and an attempt is made to access a system MMC, the error message ACCESS
DENIED will be displayed.
A four digit passcode is required to access this MMC. Each character can be digits
0-9. When opened, this MMC enables access to all MMCs.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPEAKER Used to store data and advance to next MMC
ACTION DISPLAY
1. Press TRANSFER 800.
Display shows.
ENABLE TECH.PROG
PASSCODE:
2. Enter passcode.
ENABLE TECH.PROG
PASSCODE: ∗∗∗∗
Correct code shows.
ENABLE TECH.PROG
DISABLE TENANT : 1
Incorrect code shows.
ENABLE TECH. PROG
PASSCODE ERROR
3. Enter 1 to enable or 0 to disable
OR
ENABLE TECH.PROG
ENABLE TENANT : 1
Press UP or DOWN to select.
Press RIGHT soft key to move to tenant
number and enter tenant number (1-2).
4. Press SPEAKER to advance to MMC entry
level.
801:TEC.PASSCODE
SELECT PROG.ID
Home Page
Table of Contents