OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 MAY 2009
MMC: 853 MAINTENANCE BUSY
DESCRIPTION:
This MMC is used to place stations, trunks, and common resources equipment in a
maintenance busy condition. This can be used to isolate suspected intermittent
problem equipment. Stations placed in maintenance busy will behave like a station
in DND when called. The calling stations display (if equipped) will show “MADE
BUSY” when called. Stations receiving DID or E&M type calls will receive a DND/ No
more calls tone. The station display will still function with station and date. When the
busy station is accessed, it will function like a locked out station. Trunks made busy
can not originate calls. Ring down type trunks will still ring the programmed
destination. Common resource equipment such as DSP’s, CID DSP’s and
miscellaneous equipment such as page ports, voice mail card ports can also be
placed in a maintenance busy state.
MAINTENANCE BUSY OPTIONS
0. TRK = Trunks
1. STN = Stations
2. PAGE = Page Ports
4. DTMFR:DSP = DSP # 01-48
5. CID:DSP = CID DSP # 01-42
6. R2MFC:DSP = R2MFC:DSP # 01-08
7. CONF:GRP = CONF:GRP #01-24
8. MGI = MGI Channels
9.MOBX:DSP = MOBEX DSP Resources (for Executive MOBEX)
NOTE: Selectable conditions 0 = idle state
1 = busy state
NOTE: In cases of DSP/ CID DSP selection when DSP is not mounted display will
show NONE. If mounted display will show IDLE by default.
PROGRAM KEYS
UP & DOWN Scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor or select option
SPEAKER Used to advance to next MMC
TRANSFER Exit
To Next Page
Loading...
