OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 APRIL 2007
MMC: 821 Q-SIG TRUNK
DESCRIPTION:
Provides a means of programming a PRI for normal C.O. operation or networking.
This option will only prompt for the first trunk in the span, but will affect the entire
span.
OPTIONS DESCRIPTION
NORMAL For CO operation.
Q-SIGNALLING For Q-Sig/PRI networking.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SPEAKER Used to store data and advance to next MMC
HOLD Used to delete an entry
ACTION DISPLAY
1. Press TRANSFER 821.
Display shows.
[701] Q-SIG TRK
NORMAL
2. Press UP or DOWN key to select
PRI.
[725] Q-SIG TRK
NORMAL
3. Press RIGHT soft key to move cursor.
[725] Q-SIG TRK
NORMAL
4. Press UP or DOWN key to make selection
Press RIGHT soft key to make change
[725] Q-SIG TRK
Q-SIGNALLING
and return to step 1.
5. Press TRANSFER to store and exit
OR
Press SPEAKER to store and advance to next
MMC.
DEFAULT DATA: ALL SPANS NORMAL OPERATION
RELATED ITEMS: MMC 823 NETWORK COS
MMC 824 NETWORK DIALING
MMC 825 NETWORK OPTIONS
To Next Page
