OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 APRIL 2007
MMC: 400 CUSTOMER ON/OFF PER TRUNK
DESCRIPTION:
Assigns several options (listed below) on a per-trunk basis.
OPTIONS
0 1A2 EMULATE When this option is set to ON up to 4 internal
stations can participate in a conversation on
this trunk by pressing the trunk key.
1 TRK INC. DND When this option is set to ON a trunk that is
programmed to ring a specific station (a
private line or DIL) will ring at that station if the
station is in DND.
2 TRK FORWARD When this option is set to OFF this trunk will
not follow a ringing stations call forwarding.
3 EFWD EXT CLI Uses station CID when forwarding external C.O.
lines.
4 REPEAT CLI When set to ON the CLI information sent out of
this system on a tandem trunk call will be the
CLI information received on the incoming
segment of the tandem call. When OFF the CLI
sent out of this system on a tandem trunk call
will be generated by this system.
5 TONECHK DISC When this is set to ON, loop trunks can be
disconnected by detecting busy tone (LP TRK
TONE DISC must be ENABLE in MMC 861 for
this feature to work).
6 AUTO ANSWER When ON, auto answer mode can be assigned
on a per-trunk basis.
7 COLORRING AS NOT USED IN USA.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPEAKER Used to store data and advance to next MMC
HOLD Used to clear previous entry
To Next Page
Loading...
