OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 APRIL 2007
MMC: 719 IDLE DISPLAY
DESCRIPTION:
This program allows the technician or system administrator to create 10 sixteen
character messages (pieces of information) that can be viewed by users with an
ITP-5012L model IP keyset. All 10 messages can be displayed simultaneously. The
individual user must use MMC 120 to select idle display option as “INFORMATION”.
The default setting is ‘CALENDAR”.
Messages are written using the keypad. Each press of a key will select a character.
Pressing the dial pad key will move the cursor to the next position. For example, if the
directory name is “SAM SMITH” press the number “7” three times to get the letter “S”.
Now press the number “2” once to get the letter “A”. Continue selecting characters
from the table below to complete message. Pressing the “A” key will change the letter
from upper case to lower case.
NOTE: When the character you want appears on the same dial pad key as the
previous character, press the UP key to move the cursor to the right.
• iDCS, DS and ITP KEYSETS
COUNT 1 2 3 4 5
DIAL 0 < > . ) 0
DIAL 1 space ? , ! 1
DIAL 2 A B C @ 2
DIAL 3 D E F # 3
DIAL 4 G H I $ 4
DIAL 5 J K L % 5
DIAL 6 M N O ^ 6
DIAL 7 P Q R S 7
DIAL 8 T U V
4
8
DIAL 9 W X Y Z 9
DIAL 4 : = [ ]
4
1. When the character you want appears on the same dial pad key as the previous
character, press UP to move the cursor one space to the right.
2. Other symbols are available for DIAL #.
To Next Page
Loading...
Need help?
General
