OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 APRIL 2007
MMC: 100 STATION LOCK
DESCRIPTION:
Allows the system administrator or technician to lock or unlock an individual station
or all stations simultaneously. The three options are as follows:
0 UNLOCKED Unlocks a locked station.
1 LOCKED OUTGOING The keyset cannot make calls outside the
system. It can however make and receive
intercom calls and receive incoming C.O.
calls. When in this mode the HOLD key of
an iDCS, DS or ITP keyset will flash slow
RED.
2 LOCKED ALL CALLS The keyset cannot make or receive any
calls. When in this mode the HOLD key of
an iDCS, DS or ITP keyset will light steady
RED.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPEAKER Used to store data and advance to next MMC
HOLD Used to clear previous entry
ANS/RLS Used to select ALL
ACTION DISPLAY
1. Press TRANSFER 100
Display shows
[201] STN LOCK
UNLOCKED
2. Dial station number (e.g., 205)
OR
[205] STN LOCK
UNLOCKED
Press UP or DOWN to select station and use
RIGHT soft key to move cursor
OR
Press ANS/RLS to select all stations.
[ALL] STN LOCK
??
3. Enter 0 to unlock or 1 to lock (e.g. 1)
OR
[205] STN LOCK
LOCKED OUT
To Next Page
Loading...
Need help?
General
