Samsung OFFICESERV 7100 - MMC: 720 COPY KEY PROGRAMMING

OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 APRIL 2007
MMC: 720 COPY KEY PROGRAMMING
DESCRIPTION:
Provides a tool for duplicating key assignment from one keyset to another. This can
be done on a per-station basis or on all stations, but not on a group of stations. One
limitation is that the original and target keysets must be of the same type (i.e. same
number of buttons).
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Moves cursor left and right
SPEAKER Used to store data and advance to next MMC
HOLD Used to clear previous entry
ANS/RLS Used to select ALL
ACTION DISPLAY
1. Press TRANSFER 720.
Display shows.
[201] COPY KEY
FROM:NONE
2. Enter the station number to copy to (e.g.,
205)
[205] COPY KEY
FROM:NONE
OR
Press UP or DOWN keys to make selection
and press RIGHT soft key to move cursor.
3. Enter station number to copy from (e.g., 203)
and cursor returns to step 2
[205] COPY KEY
FROM:203
OR
Press UP or DOWN keys to make selection.
4. Press RIGHT soft key to return to step 2
OR
Press TRANSFER to store and exit
OR
Press SPEAKER to store and advance to next
MMC.
Home Page
Table of Contents