OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 MAY 2009
MMC: 501
KMMC LOCKOUT TIMER This timer controls the grace period between
programming actions while in a programming session.
The timer automatically returns the system to secure
programming status.
LCR ADVANCE TIME This timer controls the duration of time before selecting the
next allowable route when a station is allowed to route
advance.
LCR INTER DIGIT This timer controls the grace period between dialing valid
digits before accessing a trunk.
LONG KEY DETECT This timer controls the time a key must be held down before
the key press is repeated.
LONG KEY REPEAT This timer controls the time between repeated digits on a
long key press.
MS LED ON TIME This timer controls the duration a Manual Signalling key will
remain on after use.
OFF HOOK RING INTERVAL This timer controls the duration of time between ring
bursts to a user who has a camped-on call.
OHVA ANSWER TIME This timer controls the time duration of an OHVA call before
automatic rejection.
PAGE TIME OUT This timer controls the duration of a page announcement.
PAGE TONE TIME This timer controls the duration of tone burst heard over the
page prior to the page announcement.
PARK RECALL TIME This timer controls the duration of time a call is parked
before recalling to the call park originator.
AP-MMC LOCK OUT This timer monitors the Installation Tool activity, drops the
link if no action is created by Installation Tool and returns
the system back to secure program status.
PERI-UCD REPORT This timer is the interval that a periodic UCD report is output.
POWER DOWN TIME This timer monitors the power to the ROM pack to begin
shutdown status.
RECALL DISCONNECT This is the time an attendant recall will ring before being
disconnected.
To Next Page
