Samsung OFFICESERV 7100 - Page 298

OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 MAY 2009
MMC: 722
3. Enter selected key number (e.g., 18)
OR
[201] KEY PROG.
18:NONE →_
Press UP or DOWN key to select key number.
Press RIGHT soft key to move cursor.
4. Using above chart, press dial pad key
number to make selection
[201] KEY PROG.
18:NONE →GPIK_
OR
Press UP or DOWN key to make selection.
Press RIGHT soft key to advance cursor to
step 5 to enter extender if required or to
return to step 2.
5. If required, enter extender (e.g.,03)
OR
[201] KEY PROG.
18:NONE →GPIK03
Press UP or DOWN key to make selection.
Press RIGHT soft key to return to step 2.
6. Press TRANSFER to store and exit
OR
Press SPEAKER to store and advance to next
MMC.
DEFAULT DATA: SEE BELOW
RELATED ITEMS: MMC 107 KEY EXTENDER
MMC 720 COPY KEY PROGRAMMING
MMC 721 SAVE STATION KEY PROGTRAMMING
• iDCS KEYSETS
Default 28 Button Keyset
01:LINE1 02:LINE2 03:LINE3 04:LINE4 05:VMMSG
06:DS201 07:DS202 08:DS203 09:DS204 10:PAGE
11:DS205 12:DS206 13:DS207 14:DS208 15:DIR
16:SPD01 17:SPD02 18:SPD03 19:SPD04 20:SPD05
21:LOG 25:CALL
22:DND 26:LISTEN
23:SPD 27:REDIAL
24:TRANSFER 28:SPEAKER
Home Page
Table of Contents