OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 MAY 2009
MMC: 724
8
FEATURE
NUMBER
This is where feature access codes are changed or
assigned. Dialing codes are entered via the dial pad
key by pressing the dial pad number, the required
steps to select this feature. For example, for OHVA,
the number 6 would be pressed three times.
NOTE: Please remember that this program is
system-wide.
9
NETWORK
NUMBER
This is where Network LCR and Remote Station
directory numbers are changed or assigned.
Network LCR ports are used for Samsung system-to-
system networking.
Remote Stations are used to create local extensions
for remote devices.
FEATURE NUMBERING DIAL KEY PAD
COUNT→
1 2 3 4
DIAL 2 ABAND BARGE CAMP ABAND
DIAL 3 DGPALM E-LCR1 FAUTO DGPALM
DIAL 4 GRPK HDSET IG GRPK
DIAL 5 LCR LCR LCR LCR
DIAL 6 MACR NEW OHVA MACR
DIAL 7 PAGE PAGE RB SETMG
DIAL 8 TCLIP UA VMADM TCLIP
DIAL 9 WAKEUP WAKEUP WAKEUP WAKEUP
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPEAKER Used to store data and advance to next MMC
HOLD Used to clear previous entry
ACTION DISPLAY
1. Press TRANSFER 724.
Display shows.
STN NUMB. :C1-S05
DLI-01:201 ~
2. Press UP or DOWN key to make selection
and press RIGHT soft key to advance cursor.
FEATURE NUMBER
ABAND :64 ~
To Next Page
Loading...
