OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 APRIL 2007
MMC: 725
10. CALLER ID† DATA This option can be selected to print Caller ID data
received from the Central Office on incoming calls. This
option requires the use of a 132 column (wide carriage)
printer or an 80 column printer set for condensed print.
11. ABANDON CALL† If this option is set to YES, unanswered calls for which CID
information was received will print on SMDR.
12. NO. OF DIAL MASK If this option is set to a numeric value, the selected last
digits of the number dialed field will be masked as
asterisks (*) on the SMDR print out. Maximum masked
digits is 18.
13. INCOMING ANSWER If this option is set to YES, the duration of calls ringing
before answered will print on SMDR.
14. INTERCOM CALL If set to YES intercom calls will print on SMDR.
15. KEY MMC IN/OUT If set to YES then the SMDR record will show
programming being opened and closed in MMC 200 and
MMC 800.
16. HOTEL CALL COST This option determines if the cost of the Hotel Room will
be presented on the SMDR printout (NOT USED IN USA).
17. HOTEL PAGE FEED This option determines at which point, the printer will
perform the page feed function (NOT USED IN USA).
18. HOTEL START LINE This option determines the point at which the system will
begin counting, to determine which line to begin printing
reports (NOT USED IN USA).
19. ITP REGISTRATION: When set to YES, whenever an ITP set registers with the
system the SMDR record will show the station number in
the EXT field and the IP address and signalling port in the
ACCOUNT field.
19. SET RELOCATION: When set to YES the SMDR record will print set relocation
activity. One station number will print in the EXT field and
the other station number will print in the ACCOUNT field.
To Next Page
