OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 MAY 2009
MMC: 833
value is 01800, meaning a check will be performed every 1.8
seconds. A setting of 00000 means that no periodic checks will
be performed. The maximum setting is 65535.
ALIVE STS: ENTRY1 AVAIL ~ ENTRY4 AVAIL:
These entries display the status of the devices at IP ADDR 1 ~
4. This status is based on a simple ping test and may not
necessarily imply full connectivity.
SIG TYPE: This option specifies the TCP/IP communications protocol to
use. The available selections are UDP (the default) and TCP.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPEAKER Used to store data and advance to next MMC
ACTION DISPLAY
1. Press TRANSFER 833.
Display shows the first table number.
TB(000)IP ADDR 1
165.213. 97.185
2. Dial the selected table number using the
KEYPAD (eg. 101)
TB(101)IP ADDR 1
165.213. 97.185
OR
Press UP or DOWN key to select a table and
press RIGHT soft key to move cursor.
3. Press UP or DOWN key to select a table entry
OR
TB(000)IP ADDR 1
165.213. 97.185
Press RIGHT soft key to move cursor.
4. Using the keypad input a 12 digit IP address
TB(000)IP ADDR 1
165.213. 97.185
5. Press UP or DOWN key to select the next
table entry or table option
TB(000)IP ADDR 1
192.168. 1. 10
6. Press TRANSFER to store and exit
OR
Press SPEAKER to store and advance to next
MMC entry.
To Next Page
