OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 JANUARY 2009
MMC: 861 SYSTEM OPTION
DESCRIPTION: [Applies to v.4.22 or Lower]
Assigns several options (listed below) on a system wide basis.
OPTIONS
0 AUTO UPDATE TIME When this option is set to ENABLE The system
will synchronize the system time and date
setting to the data received on an ISDN call
connect message. If a system has multiple PRI
cards the PRIORITY 1 setting in MMC 826 will
determine the card used.
1 SYSTEM SPEED BIN When this option is set to 500. The system will
have a maximum of 500 system speed dial
bins numbered 500 to 999. When set to 950
the system will have a maximum of 950 system
speed dial bins numbered 050 to 999. Station
speed dial bins will be 000 to 049.
Note: Personal speed dial number changes
from 2 digits to 3 digits when 950 is selected.
2 IDLE WHEN ENBLOCK When this option is enabled the ITP-5121D
keyset will receive incoming calls when dialing
out before the SEND button is pressed. When
disabled an incoming call will appear as a call
waiting call if idle CALL key is available.
Note: This option has no effect if #3 below is
disabled.
3 2 LINE ENBLOCK When this option is enabled the ITP-5121D
keyset can dial a telephone then press the
SEND button to place the call. This operates
like a cell phone. When disabled the ITP-
5121D sends each digit as you dial it.
LP TRK TONE DISC NOT USED IN USA
SPNET OVERLAP NOT USED IN USA
To Next Page
Loading...
