OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 5 APRIL 2007
5.3.49
GENERAL SCREEN:
Field Name Description
Label Name The name of this Port block
Line is wink start (DO NOT ADJUST)
Wait for loop current (DO NOT ADJUST)
Rings before
answer
(DO NOT ADJUST)
Hunt group type This should match the ring type setting in MMC 601. If MMC 601 is
set to Sequential, this setting should be 'Linear'. If MMC 601 is set
to Distributed, this setting should be 'Rotating'
Disconnect signal This setting is mainly provided to overcome issues with CO
disconnect signaling. In some cases, the CO does not send the
OfficeServ 7100 a proper disconnect signal, which can result in
the subscriber getting messages with dial tone or error tone at the
end. This field allows the system to look for a different type of
disconnect signal, such as dial tone or fast busy.
Toll saver group (DO NOT ADJUST)
Toll saver rings (DO NOT ADJUST)
Toll saver prompt (DO NOT ADJUST)
Auto clear MWI (DO NOT ADJUST)
To Next Page
Loading...
