OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 MAY 2009
MMC: 210
digits dialed are shown on the keyphone display. When
OFF, the last 11 digits are displayed.
38 ONE TCH FACC: ON
When ON, then a station may enter an account code using
a one touch account code (ACC) key. When OFF, then a
station must enter an account code by dialing via dial-pad
before making an outside call.
39 SGR ALL OUT :ON
This option, when on, allows all members to log out of a
station group.
40 CHAIN FWD :ON
When ON and a call is directed to a station that may be
forwarded to another station that is call forwarded to a
VMAA, then the caller will be directed to the last station’s
mailbox it reached. When OFF, then the caller will be
directed to the first station’s mailbox instead of the last.
41 TRK MONITER :ON
When set to ON, a barging party maintains the trunk
connection, when the barged station goes on hook. When
set to OFF, and the barged station goes on hook, all parties
are disconnected.
42 VoIP MFRALOC :OFF
When set to ON, a DTMF receiver is assigned for VoIP
tandem calling when a VoIP incoming trunk is connected to
a VoIP outgoing trunk. Note: Except when H.245 signal
mode is being used.
43 NTWK AUTOTMR:OFF
This option controls whether an intercom call across the
network link will have the auto timer come on when the call
is received.
46 PERI UCD SIO:OFF
When this option is set to ON the PERI UCD date is sent to
the UCD port type of SIO port service, instead of the PERI
UCD port type.
48 REDIAL REVW:OFF
When set to ON, this option will allow the user to review the
last number dialed before dialing.
53 PRE FWD BUSY:OFF
When set to ON this option makes the preset forward no
answer setting in MMC 316 act as forward on BUSY/NO
ANSWER.
54 ORG DIAL LOG:ON
When this option is set to ON all digits dialed from a phone
will be saved in the log.
56 VOIP REALRBT:OFF
If this option is set to ON the MGI channels will provide the
ringback tones.
58 CO-CO TM ALL:OFF
When set to ON the CO-CO TM timer from MMC 501 will
take effect for all trunks, including SPNET trunks. When set
to OFF SPNET trunks are not affected.
To Next Page
Loading...
