K.3
Date Code 20080213 Instruction Manual SEL-351A Relay
ACSELERATOR QuickSet SEL-5030 Software
Installation
Installation
To install ACSELERATOR QuickSet, perform the following steps.
Step 1. Close all other software applications on your PC.
Step 2. Insert the
ACSELERATOR QuickSet CD into your PC CD-ROM
drive. The installation program should start automatically.
a. If the install program does not start, select Run from the
windows start menu.
b. Type the following command D:\SETUP (substitute
D:\ with the CD ROM drive letter for your PC).
Step 3. Follow the steps that appear on the screen. The installation
program will perform all the necessary steps to load
ACSELERATOR QuickSet onto your PC.
It is necessary to have the correct comctl32.dll file installed on your computer
in order to see the toolbar buttons. If you do not see the toolbar buttons, run
the 40ComUpd.exe, located in the install directory. This file will install the
proper windows system drivers.
NOTE: Your PC must be restarted
after the installation for the changes
to take effect.
Courtesy of NationalSwitchgear.com
To Next Page
Loading...