EasyManuals Logo

SeaDoo 3D User Manual

SeaDoo 3D
391 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #54 background imageLoading...
Page #54 background image
Section 02 TROUBLESHOOTING
Subsection 01 (TROUBLESHOOTING CHART)
ENGINE OVERHEATS
OTHER OBSERVATION POSSIBLE CAUSE REMEDY
Temperature sensor defective (
RFI
models
)
Check/replace. Refer to ENGINE
MANAGEMENT
Cooling system restriction Check/flush, refer to MAINTENANCE
Monitoring beeper
sounds continuously
Grounded temperature sensor or sensor
wire (
carburetor models
)
Check/repair/replace
VEHICLE CANNOT REACH ITS TOP SPEED
OTHER OBSERVATION POSSIBLE CAUSE REMEDY
Faulty rev limiter
Check/replace MPEM or ECM
Engine RPM to low
Improper impeller pitch
Check/replace, refer to PROPULSION
SYSTEM
Engine RPM too high Improper impeller pitch
Check/replace, refer to PROPULSION
SYSTEM
Damaged leading or trailing edge of
impeller
Check/replace
NOTE:
Leading edge damage contributes
to poor performance from start. Trailing
edge damage contributes to poor top
performance and stator vanes erosion.
Jet pump cavitation
Sealing of ride plate, jet pump support or
jet pump
Check/reseal, refer to section
PROPULSION SYSTEM or HULL/BODY
O.T.A.S. SYSTEM FAULTS
OTHER OBSERVATION POSSIBLE CAUSE REMEDY
Engine RPM does not
increase when throttle
lever is released and
steering is turned.
Improper sequence or timing of events
when trying it.
Refer to O.T.A.S. SYSTEM
34 smr2005-046
www.SeaDooManuals.net

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SeaDoo 3D and is the answer not in the manual?

SeaDoo 3D Specifications

General IconGeneral
ManufacturerSea-Doo
Model3D
EngineRotax 947
Horsepower130 hp
CategoryPersonal Watercraft
Engine Type2-stroke
Width46.5 inches
Seating Capacity1 person

Related product manuals