SeaDoo 3D - SPECIAL PROCEDURES; SERVICE TOOLS; SERVICE PRODUCTS; TOWING THE WATERCRAFT IN WATER

Section01MAINTENANCE
Subsection 04 (SPECIAL PROCEDURES)
SPECIAL PROCEDURES
SERVICE TOOLS
Description Part Number Page
large hose pincher ................................................................
529 032 500 ...........................................19
SERVICE PRODUCTS
Description Part Number Page
Bombardier Lube.................................................................. 293 600 016 ..................................... 21–22
Loctite 518............................................................................ 293 800 038
...........................................22
TOWING THE WATERCRAFT
IN WATER
Special precautions should be taken when towing
a Sea-Doo watercraft in water.
Maximum recommended towing speed is
24 km/h (15 MPH).
When towing your watercraft in water, pinch the
water supply hose from the jet pump housing to
theenginewithalargehosepincher(P/N529032
500).
529 032 500
This will prevent the exhaust cooling system from
fillingwhichmayleadtowaterbeinginjectedin-
to and filling the exhaust system and the engine.
Without the engine running there isn't any exhaust
pressure to carry the water out the exhaust outlet.
CAUTION: Failure to do this may result in dam-
age to the engine. If you tow this watercraft in
water and do not have a hose pincher be sure
to stay well below the maximum towing speed
of 24 km/h (15 MPH).
Snugly install the hose pincher on the water sup-
ply hose as shown.
NOTE: A red tape on the water supply hose indi-
cated which hose to pinch.
F02E04A
1
GTI MODELS
1. Hose pincher
smr2005-045 19
www.SeaDooManuals.net