Section 06 ENGINE MANAGEMENT (RFI)
Subsection 03 (COMPONENT ADJUSTMENT, INSPECTION AND REPLACEMENT)
F22R05A
1
1. Cable adjuster
NOTE: When throttle cable is adjusted from this
adjuster, there is no need to readjust throttle cable
at the OTAS solenoid.
Reinstall removed parts.
Ensure to reset the Closed TPS. See below.
Ensure the OTAS system works adequately. Re-
fer to STEERING SYSTEM.
NOTE: It is not necessary to adjust the oil injection
pump cable after throttle cable adjustment. It is
not changed when throttle cable is adjusted.
THROTTLE POSITION SENSOR
(TPS)
Closed TPS (Reset)
NOTE: This operation performs a reset of the val-
ues in the ECM.
To perform the resetting, proceed as follows:
Use the VCK (Vehicle Communication Kit) (P/N 295
035 981) with B.U.D.S. software.
529 035 981
Click Reset button to reset the TPS value to pro-
vide the zero scale value to ECM.
NOTE: There will be an “EMS Tracking” message
that will say “Remove key from vehicle”.When
this occurs, remove the safety lanyard from its
post and wait until the message disappears (it
lasts approximately 15 seconds after lanyard re-
moval).
smr2005-056-050
TESTING PROCEDURES
FUEL PUMP
Refer to FUEL SYSTEM.
smr2005-056 131
To Next Page
Loading...
Need help?
General
