SeaDoo 3D - General

Section09PROPULSION
Subsection 02 (DRIVE SYSTEM)
GENERAL
Jet pump must be removed to replace any com-
ponents of the drive system. Refer to JET PUMP
for removal procedure.
Large Clamp
Unfasten large clamp no. 1 of PTO flywheel
boot no. 2 as follows:
– Use Oetiker pliers 1090 (P/N 295 000 069).
F01J0GA
– Insert pointed tips of pliers in closing hooks.
1
F01J2AA
TYPICAL
1. Closing hooks
– Squeeze pliers to draw hooks together and dis-
engage windows from locking hooks.
1
F01J29A
TYPICAL
1. Locking hooks
Secure large clamp as follows:
– Manually engage holding hook in large window.
This is a pre-clamping position only.
F01J23A
1
2
PRE-CLAMPING POSITION
1. Holding hook
2. Large window
– Insert pointed tips of pliers first in closing hooks.
smr2005-063 253
www.SeaDooManuals.net