Section01MAINTENANCE
Subsection 03 (STORAGE PROCEDURES)
STORAGE PROCEDURES
SERVICE TOOLS
Description Part Number Page
flushing connector adapter...................................................
295 500 473 ...........................................10
large hose pincher ................................................................
529 032 500
............................... 12, 14–15
small hose pincher................................................................
295 000 076
............................... 12–13, 15
SERVICE PRODUCTS
Description Part Number Page
Bombardier Lube.................................................................. 293 600 016
........................... 7, 10–11, 17
fuel stabilizer......................................................................... 413 408 600
............................................. 7
jet pump synthetic oil ...........................................................
293 600 011 ............................................. 8
Loctite antiseize lubricant..................................................... 293 800 070
...........................................11
synthetic grease ...................................................................
293 550 010 ............................................. 8
FUEL SYSTEM
WARNING
Fuel is inflammable and explosive under
certain conditions. Always work in a well
ventilated area. Do not smoke or allow open
flames or sparks in the vicinity. Fuel tank
may be pressurized, slowly turn cap when
opening. When fueling, keep watercraft lev-
el. Do not overfill or top off the fuel tank
and leave watercraft in the sun. As tem-
perature increases, fuel expands and might
overflow. Always wipe off any fuel spillage
from the watercraft. Periodically inspect fuel
system. Always turn the fuel tank valve (if so
equipped) to OFF position when storing the
watercraft.
Throttle Cable
Lubricate the throttle cable with Bombardier Lube
(P/N 293 600 016).
Fuel Hoses, Carburetor or Injectors
Verify fuel system. Check fuel hoses and injectors
or carburetor for leaks. Replace damaged hoses
or clamps if necessary.
Fuel Stabilizer
The fuel stabilizer (P/N 413 408 600) or an equiv-
alent should be added in fuel tank to prevent fu-
el deterioration and, if so equipped, carburetor
gumming. Follow manufacturer's instructions for
proper use.
CAUTION: Fuel stabilizer should be added
prior to engine lubrication to ensure fuel sys-
tem components protection against varnish
deposits.
Fill up fuel tank completely. Ensure there is no
water inside fuel tank.
CAUTION: Should any water be trapped inside
fuel tank, severe internal damage will occur to
the fuel system.
OIL INJECTION SYSTEM
Lubricate the oil pump cable with Bombardier
Lube (P/N 293 600 016).
smr2005-044 7
To Next Page
Loading...
Need help?
General
