EasyManua.ls Logo

SeaDoo 3D - Engine Stops Running; Engine Cannot Reach Maximum Rpm

SeaDoo 3D
391 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Section 02 TROUBLESHOOTING
Subsection 01 (TROUBLESHOOTING CHART)
ENGINE STOPS RUNNING
OTHER OBSERVATION POSSIBLE CAUSE REMEDY
Sparkplugheatrangetoohigh Check/change to correct range
Improper ignition timing
Check/reset
Compression ratio is too high Check combustion chamber volume
Engine dies during
operation
(piston seizure)
Poor injection oil quality
Use proper XPS 2stroke oil
Contaminated or inappropriate fuel Syphon reservoir and refill with fresh fuel
Engine stalls at idle
Air in fuel rail (
RFImodels
)
Refill fuel tank
Engine running out of fuel
Check fuel delivery system for proper fuel
pressure and delivery
Engine start but stops
after approximately
2 seconds
Air in fuel rail (
RFI models
)
Refill fuel tank
ENGINE CANNOT REACH MAXIMUM RPM
OTHER OBSERVATION POSSIBLE CAUSE REMEDY
RAVE valve does not open
(
if so equipped
)
Check, refer to the appropriate ENGINE
SHOP MANUAL and to COOLING
SYSTEM
Faulty water regulator valve
(
if so equipped
)
Check, refer to COOLING SYSTEM
Low fuel pressure
(
RFI models
)
Check fuel pump pressure
Jet pump related problem
Check propulsion components. Refer to
JET PUMP
Limp home mode activated
(
RFI models
)
Refer to ENGINE MANAGEMENT
Exhaust system blockage/muffler
damage
Check and repair
Exhaust gases in bilge (leak)
Check exhaust system for leaks
Battery voltage is too low (
RFI models
)
Check/repair, refer to CHARGING
SYSTEM
smr2005-046 33
www.SeaDooManuals.net

Table of Contents

Related product manuals