Section 09 PROPULSION
Subsection 01 (JET PUMP)
F00J0VA
2
1
1. Spring
2. Slider
Insert slider and spring into cover no. 6.
NOTE: Align the longer slider tab with hole.
F00J0WA
Apply jet pump bearing grease (P/N 293 550 032)
in the center hole of the cover.
Install pusher no. 21 into cover. Place the flat side
in front of slider tab.
F00J0XA
Install O-ring no. 8 to cover. Apply jet pump bear-
inggrease(P/N293550032)onmatingsurfaceof
cover.
Install cover to jet pump housing making sure to
properly position filler plug on top side. Do not
torque yet, keep a small gap.
Insert a pencil or any other plastic tool in the hole
and push on the slider tab.
CAUTION: Do not use a metal tool to push the
tab. It is possible to damage the inner threads.
Hold tab and torque screws.
Remove pencil or tool to release locking mecha-
nism.
Check if the mechanism worked properly. Push
tab with the pencil or tool; if there is a small play
the installation is correct. If not, redo the proce-
dure.
Verify if the impeller is rotating freely.
It is highly recommended to perform a leakage
test. Refer to PUMP PRESSURIZATION further
Add oil. Refer to OIL REPLACEMENT, at the be-
ginning of this subsection.
PUMP PRESSURIZATION
Whenever doing any type of repair on jet pump, a
pressure test should be done to check for leakage.
Proceed as follows:
– Remove filler plug from cover.
248 smr2005-062
To Next Page
Loading...
