PLC hard key
PLC hard keys are provided via the PLC interface of the HMI software, just like hotkeys. The
functions, which can be triggered via the user interface, can be configured.
They
take the form of MCP keys or evaluations of PLC signal logic operations in the PLC user
program. For this reason, they are referred to as "virtual keys".
Programming support
Provision of → Dialogs to assist programmers in writing → Parts programs with "higher-level"
components
Configuration file
File, which contains definitions and instructions that determine the appearance of → Dialogs
and their → Functions.
Recompile
NC code sections can be generated in a → Part program from input fields in → Dialogs in the
→ Programming support system. Recompilation is the reverse operation. The input fields used
to generate a selected section of NC code are retrieved from the NC code and displayed in
the original dialog.
Simulation
Simulation of a → Parts program run without movement of the actual machine axes.
Softkey labels
Text/image on the screen, which is assigned to a softkey.
Softkey menu
All horizontal or all vertical softkeys
Column index
Column number of an array
System variable
NC variable providing the NC states for parts program accesses and accesses from HMI.
Selecting
A program formulated in the NC language, which specifies motion sequences for axes and
various special actions.
Glossary
SINUMERIK Integrate Run MyScreens
Programming Manual, 10/2015, 6FC5397-3DP40-5BA3 231
To Next Page
Loading...
