MD24920 $MC_TRANSMIT_BASE_TOOL_1 [0] Vector of the base tool for the 1st TRANSMIT
transformation.
= - 600 Value in mm
If necessary, enter the same for further transformations (TRANSMIT, TRACYL).
Note also the following machine data:
MD20360 $MC_TOOL_PARAMETER_DEF_MASK Definition of the effect of the tool parameters.
Bit 3 = 0 The work offsets in frames in the transverse axis are not included as diameter value.
Offset in the Z position of the counterspindle
If the zero point of the counterspindle is not located at MCS = 0, you must enter the offset in
the following machine data:
MD53220 $MAS_AXIS_MCS_POSITION[2] [GSP] Position of the axis in the MCS
= [MCS position] e.g 1000
Fixed counterspindle
If the counterspindle does not have a traversing axis, you must enter the position of the
counterspindle in the following machine data:
MD53220 $MAS_AXIS_MCS_POSITION[2] [GSP] Position of the axis in the MCS
= [MCS position] e.g 800
Any rotary axis
If the machine has an arbitrary rotary axis that is not further defined (e.g. by the tool carrier),
you must enter the position in the following machine data:
MD53220 $MAS_AXIS_MCS_POSITION[n] [RAX] Position of the axis in the MCS
[n] 0 = X, 1 = Y, 2 = Z
7.5.13 Spindle speed limitation for current program
Speed limits are programmed in the part program. If the part program is applied, the spindle
speed limits are entered in the setting data and saved there after the end of program.
However, if the modified speed limits must not apply after the end of the program, you can
change the property with the following commands in the GUD block of the machine
manufacturer:
Configuring cycles
7.5 Turning
SINUMERIK Operate
132 Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
To Next Page
Loading...
Need help?
General
