Siemens SINUMERIK 828D

<CHANNELMAGAZINEASSIGNMENT>
<CHANNELNO_1>
<Magazines value="1 2 3" type="QString" />
</CHANNELNO_1>
<CHANNELNO_2>
<Magazines value="4" type="QString" />
</CHANNELNO_2>
<CHANNELNO_3>
<Magazines value="5" type="QString" />
</CHANNELNO_3>
<CHANNELNO_4>
<Magazines value="6" type="QString" />
</CHANNELNO_4>
</CHANNELMAGAZINEASSIGNMENT>
Example 2
Magazine location 1 of the buffer will be assigned to channel 1.
Magazine location 2 of the buffer will be assigned to channel 2.
<CHANNELMAGAZINEASSIGNMENT>
<CHANNELNO_1>
<MAGAZINE_9998>
<Places value="1" type="QString" />
</MAGAZINE_9998>
</CHANNELNO_1>
<CHANNELNO_2>
<MAGAZINE_9998>
<Places value="2" type="QString" />
</MAGAZINE_9998>
</CHANNELNO_2>
</CHANNELMAGAZINEASSIGNMENT>
9.2.19 Assignment
between magazines and
magazine locations and coordinate systems
Requirement
Turning technology or milling technology and technology extension turning have been set:
Name of the associated configuration file sltmturninglistconfig.xml or sltmmillturnlistconfig.xml.
Tool management
9.2 Configuring the user interface
SINUMERIK Operate
274 Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3